Reduce Springback, increase productivity, while cutting cost with Quintus Technologies

The Flexform™ Difference

Many companies, particularly in the aerospace market, use Flexform™ to form the majority of their sheet metal production parts. Fluid cell forming is perfectly suited to the relatively low-volume requirements of commercial, military and business aircraft. Quick cycle models can produce up to 120 parts per hour, and automated pallet systems can substantially improve efficiency in longer production runs.

Evaluate your sheet metal forming production,identify your most labor intensive part, and send it to us for a FREE evaluation.

The Process: High Pressure vs Low Pressure

  • The part formed at 350 bar came from a pre-cut blank with a width of 145mm.
  • The blank for the 800 bar test was 160mm width, with the extra material used for the shrink flange and draw dam with cutting edge.
  • If the larger blank would have been used to form the 350bar part, then there would have been an even greater increase in wrinkling.

Ideal for Low Volume Production of Parts with Complex Shapes

» Increase capacity by 50-80%
» Flexform results in high quality, low cost parts
» Excellent for airframe fabrication
» Forming simulation

sheet metal forming aerospace

Take Your Lead Time Savings from Weeks to Hours

» Need for only one single rigid tool half cut manufacturing time
» Cost for late design changes are minimized
» Need for tool alignment to fit a specific sheet thickness is eliminated


Cut Tool Cost by up to 90%

» Tool cost savings - typically in range
of 50 - 90%
» Low volume and niche-industry parts are no problem for Flexform technology
» Parts can range from small shallow parts to large, deep parts

Send in your drawing for a free part evaluation

Download an Example of our Flexform Pay-Back Analysis