Let Quintus Help You Tackle the Challenges for Automotive Suppliers.

Book a Free Meeting

25 – 26 September

Explore our Sheet Metal Forming products

QFC 0.7 x 1.8 - 800 sheet metal forming presses

Fluid Cell Presses

Rectangular Trays

Quintus offers a full line of standard models of Flexform™ Presses with rectangular trays dimensions up to 1.8 x 3.6 m (71 x 142 in) and pressures from 800 bar (11,600 psi) to 1,400 bar (20,000 psi). The cycle time is normally one to three minutes, depending on press size, formed parts and selected pressure.

Fluid Cell Presses

Circular Trays

QFL presses are compact units with circular trays, designed for faster forming of smaller parts.
Cycles average about one minute, with maximum pressure of 800 bar (11,600 psi). These presses are commonly used for off-loading and back-up for larger rectangular tray presses and for rapid forming of smaller parts.

Modern Quintus Fluid Cell Deep Draw Press

Fluid Cell Presses

Deep Draw Presses

Quintus offers a line of standard deep-draw press models with forming area/diameter ranging from 560 mm / 22 inch to 1100 mm / 43.3 inch. Pressure ranges from 800 bar / 11,600 psi to 1,200 bar / 17,400 psi. The cycle time is depending on the tool size and the pressure level required, but normally range from some 30 seconds to two minutes.

Quintus Technologies High Pressure Warm Forming Press

Fluid Cell Presses

High Pressure Warm Forming

The Flexform™ High Pressure Warm Forming process is a new technology that can replace or complement existing Titanium forming methods, such as hot-forming, hot stamping, super plastic forming, SPF, and hot gas forming. Benefits: 50% reduction in production costs, five times increased throughput, and forming repeat-ability